Connection Of The Ground Connection; Safety Instructions For The Ground Connection; Wiring Process For The Ground Connection - Ingeteam INGECON SUN 1Play HF U Manual De Instalacion Y Uso

Connection of the ground connection

8. Connection of the ground connection
These units offer the possibility of grounding the positive or negative pole of the PV array if desired.
This section explains the process for connecting the cabling to ground the unit.
Read carefully before starting the connection process.

8.1. Safety instructions for the ground connection

Consult section "Important Safety Instructions" and the following instructions before working on the
unit.
Make sure there is no voltage present on the unit before starting the connection.
Do not switch on the power to the unit until you have successfully made the rest of the connections
and the unit is closed.
Ingeteam accepts no liability for any damages caused by incorrect connection.
Use the personal protective equipment specified in the section "Personal Protective Equipment
(PPE)".

8.2. Wiring process for the ground connection

The unit comes from the factory without grounding. If you wish to ground one of the two poles, proceed as
indicated in the following figures:
Without ground connection (J103, factory
default status)
In addition to the connection described, you must configure the unit using the display (see section "12.6.4.
Settings").
ABF2013IQM01_ - Installation and Operation Manual
Ground connection of the positive pole
(J8)
Ingeteam
Ground connection of the negative pole
(J5)
EN
ES
27