Package Contents; Description (Fig. A); Electrical Safety - DeWalt DW849 Manual De Instrucciones

● Always wear eye and ear protection. Preferably
wear other personal protective equipment such
as dust mask, gloves and a helmet.

Package contents

The package contains:
1 Polisher
1 Backing pad
1 Threaded flange
1 Polishing bonnet
1 Side handle
1 Instruction manual
1 Exploded drawing
● Check for damage to the tool, parts or accessories
which may have occurred during transport.
● Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. A)
Your D WALT polisher DW849 has been designed
E
for professional polishing of painted metal surfaces
(e.g. car bodies) and natural stone surface finishing.
1 Variable speed switch
2 Lock-on button
3 Speed control dial
4 Spindle lock
5 Side handle

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
#
E
accordance with EN 50144; therefore
no earth wire is required.
115 V units have to be operated via
@
a failsafe isolating transformer with an
earth screen between the primary and
secondary winding.
Mains plug replacement
(U.K. & Ireland only)
● Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
● Disconnect the plug from the supply.
● Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
● Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
● The cable wire colours, or a letter, will be
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see below). Brown
is for Live (L) (2) and Blue is for Neutral (N) (4).
● Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
!
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding
1500 W, we recommend to fit a plug to BS4343
standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
machine (see technical data). The minimum
conductor size is 1.5 mm
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Conductor size (mm )
2
0.75
1.00
1.50
2.50
4.00
E N G L I S H
.
2
Cable rating (Amperes)
6
10
15
20
25
.
21