BH FITNESS G-6452 Instrucciones De Montaje Y Utilización página 18

earthed wall sockets, as shown in
Figure A. An inadequate electrical
connection may result in electrical
shocks. If the plug is not suitable for
the wall socket then change it for one
that matches, bearing in mind that the
earth wire must always be connected.
If in doubt, call BH technical services.
4
Never leave the unit unattended
when it is plugged in. Unplug it after
use.
5
Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
6
Never use
recommended by the manufacturer.
7
Do not use the machine if the mains
cable becomes damaged or worn.
8
Keep the mains cable away from hot
surfaces.
9
Do not use the machine outdoors.
10
To unplug the machine, first put the
switch to the "0" position and then
unplug it from the wall socket.
SAFETY BREAKER
This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This safety
automatically triggered if the unit is
subjected to abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position.
2.- Press the circuit button (C) to
reset the unit.
3.- Next, set switch (L) to the "I"
(ON) position and the unit will be
ready for use again.
Should the
repeatedly then the most probable
accessories
device will
circuit breaker
causes are:
- Abnormal working conditions,
- Treadmill belt in need of lubricant,
- Solvent based lubricants used (use
BH type),
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
not
ASSEMBLY INSTRUCTIONS
Take the unit out of the box and place
it on the floor as shown in Figure 0.
The assistance of a second person is
advisable for the assembly work.
Make sure that all of the pieces are
there:
(B) Main structure; (E) Side bar base
cover (Left); (F) Side bar base cover
(Right); (a) Allen screw M5x10; (f)
Allen key 6 mm; (g) Safety key; (i)
Bottle of lubricant.
be
Follow the instructions step by step to
assemble:
1.-
First loosen the two top holding
knobs (K) by two turns, anticlockwise,
Fig. 1, next take hold of the handrails
(G and H) and lift them in the direction
of the arrow, as shown in Fig. 2, until
you hear the top holding knobs (K)
click into position.
2.-
Now loosen off the bottom holding
knobs by two turns (L) Fig. 3.
trip
Holding the handrails (G and H), lift
18