BH FITNESS G-6452 Instrucciones De Montaje Y Utilización página 19

the focus bars in the direction of the
arrow, see Fig. 4, until you hear the
bottom holding knobs (L) click into
position.
NOTE: Make sure that you hear the
top holding knobs click into the
handrails and the bottom knobs click
into the focus bars before you let go of
the handrails.
3.-
Once you have completed the
above, tighten the top knobs (K)
securely, Fig. 5, by turning them
clockwise and the bottom knobs (L)
Fig. 5, by turning it clockwise.
4.-
Position the left and right base
covers (E) and (F) in the direction of
the arrow facing the corresponding
side bar, as shown in Fig. (6) and
attach them by using screws (a), as
shown in Fig. (6).
ATTENTION: Cylinder (Q) Fig (7) is
factory set to high pressure so it must
not be knocked. If it is knocked this
may damage
operation of the treadmill
FOLDING YOUR UNIT
This treadmill is equipped with a
safety release
folding purposes.
To fold and store the unit follow the
instructions below:
Before attempting to fold the unit, stop
the belt, lower the elevation setting to
minimum and unplug the cable from
the mains socket.
To fold the unit follow the instructions
below:
First, using one hand, pull the red
knob marked number (1) in the
direction of the arrow, Fig. 7A.
Then, without releasing the red knob,
use the other hand to lift the machine,
marked number (2), in the direction of
it and impair
mechanism
the arrow as shown in Fig. 7A.
Lift and fold the machine up until you
hear it lock into position (O), located at
the bottom of the machine, Fig. 7
Store your unit in a dry place,
preferably not subject to changes in
temperature.
UNFOLDING YOUR UNIT
If you wish to use the treadmill, do the
reverse procedure. Use your foot to
press lever (O) in the direction of the
arrow as shown in Fig (7) and slowly
lower the treadmill belt down to the fl
oor. When folding or unfolding the
treadmill make sure that there are no
children about or obstacles that might
hinder the folding motion.
MOVEMENT & STORAGE
The unit is equipped with wheels (P),
Fig. (8) to make it easier to move.
Make sure that the mains cable is
unplugged from the wall socket.
If you wish to move the treadmill, the
the
first thing to do is to fold it up, place
your hands on the handrails (G & H)
and tilt the treadmill, Fig (8), so that
the wheels (P) rest on the floor.
To prevent accidents DO NOT move
for
the treadmill across uneven floors.
MAINTENANCE
Use the bottle of lubricant (i) to
lubricate the inside of the belt in order
to keep your unit in top condition and
to ensure that friction between the belt
and the board is kept to a minimum
(due to different running styles, always
apply more lubrication to the area
where you place your feet during the
exercise) It is advisable to lubricate
the base of the belt every 3-12
months, depending on how often it is
used.
If the belt starts to slip after lubrication,
19
.