Johnson 40-6527 Manual De Instrucciones página 14

1625i-All_Manuals 12/28/16 3:07 PM Page 14
(e) Detecting Laser Level Signals
While detecting laser signals, the LCD will display as follows: (take
the set-up state of high sound and fine detection as an example)
Laser signal
The laser signal is down
Sound: rapid short beeps
When the laser signal is near the on-grade mark, the displayed up
and down arrows will decrease as the distance to the on-grade
mark decreases.
Laser signal
1. When detecting a horizontal laser signal, it is
important to have the bubble vial centered, as the
deflection of the receiver will influence its receiving
accuracy.
2. When detecting a vertical laser signal, it is
important to have the bubble vial centered, as the
deflection of the receiver will influence its receiving
accuracy.
14
Laser signal
The laser signal is up Horizontal bar indicated on-grade
Sound: slow short beeps Sound: continuous sound
Laser signal
Laser signal
No laser signal is detected
Sound: no sound
Laser signal Laser signal
©2016 Johnson Level & Tool - Rev. 2