Operating Instructions; Battery Installation - Johnson 40-6527 Manual De Instrucciones

1625i-All_Manuals 12/28/16 3:07 PM Page 6

6. Operating Instructions

IMPORTANT: It is the responsibility of the user to verify the
calibration of the instrument before each use.

Battery Installation

Note: Always check to be sure that the on/off switch is in the off
position before removing and replacing batteries.
Usage for Rechargeable (40-6532 & 40-6539) & Alkaline Battery Cases
1. Put 4 "C" alkaline batteries into the battery case according to the
polarity indication shown in the battery case.
2. Put the battery case on the instrument and tighten the locking screw.
3. If using the rechargeable (40-6532 & 40-6539) battery pack, put
the battery box on the instrument and tighten the locking screw.
Note (40-6532 & 40-6539):
• For the first two charges of a new rechargeable battery pack, it is
necessary to charge for 12-plus hours.
• The instrument will still work even if it is being charged with the
charger.
• Do not charge alkaline batteries.
• Used (discharged) batteries are hazardous waste and should be
disposed of properly.
6 ©2016 Johnson Level & Tool - Rev. 2