Johnson 40-6527 Manual De Instrucciones página 18

1625i-All_Manuals 12/28/16 3:07 PM Page 18
3. Operation Guide
(a) Battery Installation
• Open the battery-box cap and connect the cords inside with the
two polarities of the 9V battery. Note: Take the battery out if
detector is not used for a long time.
• Put the 9V battery into the battery box and close the battery-box cap.
(b) Power on
• Press the on/off button. When power symbol is
• When low battery symbol is displayed, change the
• Press the on/off button again to turn off the detector.
(c) Rod Clamp
(d) Detecting Laser Level Signals
1. Coarse detection
18
displayed, the detector is ready for coarse detection.
battery.
1. clamp bolt
2. screw
• Position the detector on the clamp holder using
the screw on the clamp holder.
• Position the clamp holder on rod using the clamp
bolt on the clamp holder.
• Aim the receiving window at the rotating
laser. Loosen the clamp bolt and move the
detector up and down to receive the laser
signals transmitted by the rotating laser.
©2016 Johnson Level & Tool - Rev. 2