Tool Change; Removing The Chuck; Tips And Tricks - Metabo SBE 500 Instrucciones De Manejo

7.6

Tool change

Keyless chuck Futuro Plus
See illustrations, page 3.
Insert tool. Hold ring (a) and turn the sleeve (b) with
your other hand in direction "GRIP, ZU" until
further rotation is impossible.
With a soft tool shank, retightening may be
required after a short drilling period.
Opening chuck: Hold ring (a) and turn the sleeve (b)
with your other hand in direction "AUF, RELEASE".
Note: The ratchet sound which can possibly be
heard after opening the drill chuck, is functional
and is switched off by a reverse rotation of the
sleeve.
If the chuck is very securely tightened: Unplug.
Hold drill chuck using an open-end spanner at the
flats on its head and turn the sleeve (b) vigourously
in direction of "AUF, RELEASE".
7.7

Removing the chuck

Keyless chuck Futuro Plus
Undo the locking screw. Caution left-handed
thread!
Hold the drill spindle tight with an open-ended
spanner. With a light blow from a rubber hammer,
release the chuck from the clamped hexagon
spanner and unscrew it.

8 Tips and Tricks

In the case of deep bores pull the drill bit out of the
bore from time to time in order to remove the bore
dust or shavings.
The chuck can be removed for screwdriving. Insert
screwdriver bit directly in the hexagon socket of
the spindle.
When the bit spring collet is fitted, the screwdriver
bit is held in position.
9 Maintenance
Keyless chuck cleaning:
After prolonged use hold the chuck vertically, with
the opening facing down, and fully open and close
it several times. The dust collected falls from the
opening. Regular use of cleaning spray on the jaws
and jaw openings is recommended.
f
10 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Metabox
B Angle Drilling and Screwdriving Attachment
C Flexible Shaft
D Rubber Backing Pad
E Linen-backed Sanding Discs
F Drill Stand
(drill clamp can be rotated by 360°.)
G Moulding & Drill Stand
(Column with toothed rack and guide groove)
H Machine Vice
I Steel-wire End Brush
J Steel-wire Cup Brush
K Steel-wire Wheel Brush
L Fitting bit spring
For complete range of accessories, see
www.metabo.com or the main catalogue.
11 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
ENGLISH
ENG
11