Cleaning And Maintenance - Ferm ESM1009 Traducción Del Manual Original

USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
switch (1).
● To switch off continuous mode, press the
on/off switch (1) again.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting the
speed. The speed adjustment wheel can be set to 6
positions. The ideal speed depends on the required
grain size and on the material to be worked.
2
Do not set the speed during use.
● Turn the speed adjustment wheel (3) to the
required position.
- For hard materials, use sanding paper with
a fine grain size and select a lower speed.
- For soft materials, use sanding paper with a
coarse grain size and select a higher speed.
Dust extraction (fig. C)
● Insert the dustbag (9) into the dustbag
connection (7).
● Turn the dustbag (9) clockwise until it locks
into place.
Hints for optimum use
● Clamp the workpiece.
● Firmly hold the machine with both hands.
● Switch on the machine.
● Place the sanding pad with sanding paper on
the workpiece.
● Slowly move the machine over the workpiece,
firmly pressing the sanding pad against the
workpiece.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.

CLEANINg AND MAINTENANCE

4
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
● Regularly clean the sanding pad to avoid
inaccuracies during use.
Replacing the sanding paper (fig. B)
● To remove the old sanding paper (8), proceed
as described in the section
„Mounting and removing the sanding paper".
● To mount the new sanding paper (8), proceed
as described in the section
„Mounting and removing the sanding paper".
Replacing the sanding pad (fig. D)
In case of wear, the sanding pad must be replaced.
● If necessary, remove the sanding paper.
● Loosen the screws (10) from the sanding pad
(4).
● Remove the old sanding pad (4).
● Mount the new sanding pad (4).
● Tighten the screws (10) to the sanding pad (4).
wARRANTy
Consult the enclosed warranty terms.
ENVIRONMENT
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
7