Multiplex MULTImate V 1.42 Manual De Instrucciones página 28

2.1 M 1-6: PC-C
ENU
This menu is used to update the MULTImate to the latest software version. The software program MULTImate Updater
is available as a free download at the website: www.multiplex-rc.de. This ensures that the MULTImate is future-proof. In
fact, it is already set up to cater for new generations of receivers, servos and speed controllers and other types of
device from the MULTIPLEX stable!
• Obtain the optional PC Interface lead (USB PC lead, # 8 5149, or the serial PC lead, # 8 5150) and connect it to the
PC or laptop and the PC and Data port at one end of the MULTImate. If using a USB-PC lead: install driver.
• Switch the PC or laptop on, and start the MULTImate Updater program. Now transfer the software update by
following the directions included in the operating instructions supplied with the MULTImate Updater.
Action & Display
1-6 PC-Com
1-6 Ready!
Note: if the MULTImate starts with an empty screen and the backlight switched on, the device contains no software
program. The most likely cause is an error during the Update process, in which the software was erased.
Open the MULTImate Updater PC program and carry out the Update procedure again, as described in Sections
starting at Step 4 and also
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
OM
1-6 Go back
...to MULTImate
5.2 of the operating instructions supplied with the MULTImate Updater.
Explanation
Main menu display
„1-6 PC-Com" (PC-communication)
When the update process is complete, the MULTImate
automatically switches itself off.
5.1
Seite 5/22