Multiplex MULTImate V 1.42 Manual De Instrucciones página 42

10. M 9: S
ENU ERVOTEST
Servo signal generator for adjusting and testing servos, speed controllers etc., without transmitter and receiving system.
• Connect the UNI lead attached to the servo to the PC and Data port on one end of the MULTImate.
Note: In "Servo test" mode you may notice the screen display and the screen backlight flickering slightly. This is not a
fault in the device; it simply reflects the irregular current drain of the servo motor.
Action & Display
9 Servotest
9-1 Manual
0 µs
9-2 Automatic
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
9 Go back
...to main menu
9-1 Manual
1500 µs
9-2 Go back
...to servotest
9-2 Max. left
1450 µs
9-2 Max. right
1550 µs
9-2 Speed
5
9-2 Servo move
like stick
9-2 Servo
running...
Explanation
Main menu display „9 Servotest"
Setting the servo in manual mode
When the display shows 0 µs the servo is "soft", i.e. it
receives no control signal
Setting (moving) the servo in "Manual" mode
• Range of values: 900µs, ..., 2100µS
• When the value "1500µs" (servo centre setting)
flashes, this signal length is passed to the servo.
Change the signal length (pulse width) using
conclude the manual servo test with . After
conclusion the screen again displays: "8-1 Manual 0
µs" or "8-1 Manuell 0 µs"
Setting the servo in "Automatic" mode
Concluding the automatic servo test
•
concludes the automatic test process, i.e. the
servo stops running
Setting the left servo end-point
• Range of values: 900µS, ..., 1450µS
• Activate the menu point using , then
setting the value, confirm the set value with
Setting the right servo end-point
• Range of values: 1550µS, ..., 2100µS
• Activate the menu point using , then
setting the value, confirm the set value with
Setting the servo transit speed
• Range of values: 5, ..., 40
• Activate the menu point using , then
setting the value, confirm the set value with
Setting the type of simulation (rotary movement)
• Control "like stick" / "wie Knüppel" (smooth movement)
or "like switch" / "wie Schalter" (abrupt movement)
• Activate the menu point using , then
value. Confirm the set value with
Servo immediately runs to the set values
The servo automatically moves from left to right
or ,
or for
or for
or for
or to set the
Seite 19/22