Multiplex MULTImate V 1.42 Manual De Instrucciones página 40

8-6 Load reduce
off
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
8-5 Set middle
0
8-5 Set end 1
290
8-5 Set end 2
-290
8-5 Set failsafe
0
Setting the servo centre position
**
Mechanical position of the servo output device for
1500µS (neutral signal)
•
Range of values -290, ..., +290
•
To set the value: , then
. MULTImate confirms the input with "--> OK!"
Setting servo end-point 1
The set value corresponds to the end-point to which the
servo runs when it is fed a signal length of 900µs or
2100µs (according to the servo direction "on" / "off" or
"ein" / "aus").
•
Range of values: 290, ..., +3000***
•
To set the value: , then
MULTImate confirms the input with "--> OK!"
Setting servo end-point 2
The set value corresponds to the end-point to which the
servo runs when it is fed a signal length of 900µs or
2100µs (according to the servo direction "on" / "off" or
"ein" / "aus").
•
Range of values: -3000***, ..., -290
•
To set the value: , then
MULTImate confirms the input with "--> OK!"
Setting the servo fail-safe position
•
Range of values: -3000***, ..., + 3000***
•
To set the value: , then
MULTImate confirms the input with "--> OK!"
Setting load reduction for digital servos with
MULTIPLEX digi 5 or HiTEC G2 electronics
This parameter defines the extent to which a digital
servo gives way after a certain time delay when under
excessive load.
Example: 20% load reduction means that the servo
only delivers 80% of full power when the time delay has
elapsed. This effectively prevents an overload situation
for the servo and / or the power supply.
• Value range: "off" or "aus", "10%", "20%", "30%",
"40%", "50%"
• To set: , then
or , confirm with
or , confirm with .
or , confirm with .
or , confirm with .
, confirm with
or
Seite 17/22