Multiplex MULTImate V 1.42 Manual De Instrucciones página 38

8. M 7: MULTI
ENÜ
The MULTImate can be used to program MULTIcont BL-XX S-BEC speed controllers (BL-40 S-BEC, BL-55 S-BEC and
BL-70 S-BEC).
• Locate the UNI lead attached to the MULTIcont S-BEC speed controller, and connect it to the PC and Data port on
one end of the MULTImate.
Action & Display
7 MULTIcont SBEC
7-1 Battery mode
LiPo
7-2 Brake
off
7-3 Reverse
off
7-4 Cutoff type
reduce power
7-5 Softstart
on
7-6 Timing
automatic
7-7 Frequency
8 kHz
7-8 Model type
Airplane
7-9 Send data
L
Notes:
• It is essential to send the set values or data to the MULTIcont BL-XX S-BEC speed controller using menupoint 6-9,
otherwise they will not take effect.
• After you call up the menu, the unit reads out the values currently set in the speed controller. For this reason you
only have to concern yourself with the parameters you wish to re-program.
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
SBEC
CONT
7 Go back
...to main menu
Explanation
Main menu display „7 MULTIcont SBEC"
Setting the battery type
• The battery type "LiPo" or "NiXX" can be selected
using and or , confirm the setting with
Setting the brake function
• Brake "on" / "off" or "ein" / "aus" can be selected using
and or , confirm the setting with
Setting the direction of motor rotation
• Motor reverse "on" / "off" or "ein" / "aus" can be
selected using and
with
Setting the motor power-off mode when the
minimum voltage threshold is reached
• Hard power-off "switch off" or "sofortiger Stop" or
reduced power ("reduce power" or "Leist.reduz. ")
can be selected using and
Setting the motor start-up behaviour
• Soft-start "on" / "off" or "ein" / "aus" can be selected
using and or , confirm the parameter with
Setting the timing
• Timing setting "7 degrees" / "30 degrees" / "automatic"
or "7 Grad" / "30 Grad" / "automatisch" can be
selected using and
Setting the pulse frequency
• Pulse frequency setting "8 kHz" / "16 kHz" can be
selected using and
Setting the model type
• The "Airplane" / "Heli" or „Flächenmodelle" /
"Hubschrauber" (= governor mode) setting can be
selected using and
To send the selected settings:
or , confirm the parameter
or , confirm with
or , confirm the setting with
or , confirm the setting with
or , confirm the setting with
Seite 15/22