Assembly Instructions; Install And Adjust The J-Handle; Install The Harness - Troy-Bilt TB490BC Manual Del Operador

On some units, the J-handle may be pre-installed. In this
case you must loosen screws and adjust the handle to fit
the operator. Go to step 5 if the J-handle is pre-installed.

INSTALL AND ADJUST THE J-HANDLE

1. Place the J-handle between the top and middle
clamp pieces (Fig. 1).
(4) Screws
Bottom Clamp
Nuts
2. While holding the three pieces together, install the four
(4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up
only when assembled correctly.
3. Place the clamps and the J-handle over the shaft
housing and onto the bottom clamp.
4. Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
5. Slide the J-handle in or out until the arrow/white line on
the decal touches the clamp assembly (Fig. 2). You must
first loosen the screws if the handle is pre-installed.
Decal
6. While holding the unit in the operating position (Fig. 3),
position the J-handle to the location that provides you
the best grip.
7. Tighten the clamp screws evenly, until the J-handle
is secure.

ASSEMBLY INSTRUCTIONS

J-Handle
Top Clamp
Middle Clamp
Fig. 1
Fig. 2
Fig. 3

INSTALL THE HARNESS

WARNING: Always use the shoulder
harness when using the cutting blade to
avoid serious personal injury.
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 4).
3. Put the harness on over head and onto shoulder.
Snap it on to the support fitting (Fig. 5).
4. Adjust length to fit the operator's size. Pull tab to
lengthen, pull strap to shorten (Fig 6).
REMOVE AND INSTALL THE CUTTING
ATTACHMENT SHIELD
Remove the cutting attachment shield when
using the unit as a brushcutter
WARNING: The cutting attachment shield
should NOT be installed when operating
the unit with a blade. Remove the cutting
attachment shield before removing or
installing the blade.
Remove the cutting attachment shield from the shield
mount by removing the three (3) screws with a flat blade
screwdriver (Fig. 7). Store parts for future use.
Fig. 4
Support Fitting
Fig. 5
Fig. 6
7