BH FITNESS H853 Instrucciones De Montaje página 17

5. FITTING THE SLIDE TUBE.-
Place the slide tube (8) on the main
frame tube (1) and rear main frame
tube (9), Fig.5, insert the bolts (76)
and washers (65).
Remove the pre-assembled screws
(84) from the slide bracket (7), place
the adjustable bar (15) to the side of
the slide bracket (7) and refit the
screws (84), Fig.5.
Attach the right and left upper rear
covers (33), (34) using the screws
(88), Fig.6.
Attach the right and left lower rear
covers (31), (32) using the screws
(88), Fig.6.
Attach the right and left main frame
covers (29), (30) using the screws
(88), Fig.6.
6. FITTING THE SEAT.-
Remove the pre-assembled bolts (77)
and washers (65) from the slide
bracket (7).
Attach the right handlebar (4) to the
side of the slide bracket (7) and refit
the bolts (77) and washers (65), Fig.7.
Attach the left handlebar (5) to the
side of the slide bracket (7) and refit
the bolts (77) and washers (65), Fig.7.
Attach the seat post (6) to the slide
bracket (7), Fig.8, using the bolts (76)
and washers (65).
Remove the pre-assembled bolts (77)
and washers (65) from the seat (19A).
Attach the seat (19A) to the seat post
(6) as shown on Fig.9, refit the botls
(77) and washers (65) and tighten
securely.
Attach the backrest (19B) as shown
on Fig. 9 and fix it with the knobs (53).
7. FITTING THE FRONT POST –
H853.-
Remove the pre-assembled bolts (77),
washers (66) and (65) from the main
frame (1). Insert the front cover (35) to
the front post (2). Insert the wire (59)
into the front post (2) and through the
hole of the tension control, Fig.10A.
Bring the front post (2) close to the
main frame tube (1), connect the wires
(58) and (89), Fig.10A. Attach the front
post (2) to the main frame tube (1) and
refit the bolts (77) and washers (66)
and (65), making sure not to snag any
of the cables. Lower the front cover
(35) to the main frame, Fig.10A.
Insert the tip of the cable sheath (59)
into the cable tension control support
(57), as shown in Fig.10A, pull the
sheath (59) up slightly and insert it into
the slot, see Fig.10A.
Attach the tensión control (57) to the
front post (2) using the bolt (70) and
washer (71), Fig.10A.
7. FITTING THE FRONT POST –
H854B.-
Remove the pre-assembled bolts (77),
washers (66) and (65) from the main
frame (1). Insert the front cover (35) to
the front post (2), Fig.10B. Bring the
front post (2) close to the main frame
tube (1), connect the wires (58) y (59),
Fig.10B. Attach the front post (2) to
the main frame tube (1) and refit the
bolts (77) and washers (66) and (65),
making sure not to snag any of the
cables. Lower the front cover (35) to
the main frame, Fig.10B.
8. FITTING THE HANDLEBAR.-
Bring the handlebar (3) close to the
front post (2), insert the hand pulse
wire (60) through the hole of the front
post (2). Attach the handlebar (3) to
17