AXXAIR SAXX-200 Manual De Instrucciones página 60

INNOVATIVE ORBITAL SOLUTIONS
If mode « tacking auto » :
If mode « tacking auto » :
Level and overlap :
Join experience
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Choice between 4 and 8 tacks.
Tack parameters:
Tacking pregas: After moving, the machine
stays at the same place during this pregas
time before tacking.
Preheating: Current is the same for orbital
welding but time can be different.
Tacking time: currents and pulse times will
be used during this time. You can choose
to pulse or to have a constant current by
pressing the button "Current".
Tacking postgas:
After a tacking, the machine stays at the
same place during this postgas time before
moving to the next tacking.
The start angle is the angle between the
last tacking and the beginning of the orbital
welding.
Level and overlap parameters:
- You have on this screen all the
parameters used during rotation around the
tube: currents, pulse times, advance speed,
wire speed, angle and direction.
- All these parameters can be freely
adjusted for each level.
- Use buttons on the left of the screen to
pulse or not the parameter.
- Total of level angles should be 360°. Then
you have the overlap screen.
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 60 -
English