Welding - AXXAIR SAXX-200 Manual De Instrucciones

INNOVATIVE ORBITAL SOLUTIONS

4.7. Welding :

Manual torch
mode
To move
manually
machine and
wire
Start/stop manually the cooling unit. Indicator shows if flow is
detected or not.
Join experience
Start and stop manually the gas so as to check if
bottle is open and connector well connected. If a flow
is detected, green indicator is illuminated.
The torch gas stops automatically after 90s (unless a
cycle has been started meanwhile), which is not the
case of the internal gas. A liter counter allows you to
know how much internal gas has been sent since the
activation of the line. This counter is reset as soon as
the line is deactivated. If the internal gas has been
activated manually before a welding cycle, it will be
stopped at the end of the cycle if the program
manages the gas flow, otherwise not. In all cases, the
gas flow alarms are active if the gas is sent.
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 65 -
To weld with a
program.
To freely modify
parameters during
welding (not
accessible to
operator).
To test rotation of
program.
After selected one of
these functions, you
have to choose the
program you want to
use.