M
U
GENERAL INSTRUCTIONS
• This booklet constitutes an integral and essential part of the product and should be
supplied to the installer. Read the instructions contained in this booklet carefully as
they give important directions regarding the safety of installation, use and maintenan-
ce. Preserve this booklet with care for any further consultation. The installation of the
burner must be carried out in compliance with current regulations, according to the in-
structions of the manufacturer and by qualified personnel. An incorrect installation can
cause injury or damage to persons, animals and objects, for which the manufacturer
cannot be held responsible.
• This appliance should only be used for the purpose it has been designed for. Any
other use is to be considered improper and therefore dangerous. The manufacturer
cannot be considered responsible for any damages caused by improper, erroneous or
unreasonable use.
• Before carrying out any cleaning or maintenance operation, disconnect the appliance
from the power supply, by using the main system switch or through the appropriate
interception devices.
• In case of failure and/or malfunctioning, switch off the equipment and refrain from
trying any repair or direct intervention. Call in qualified personnel only. Any repair must
be carried out by a servicing centre authorised by the manufacturing
firm, one using original replacements exclusively. Non-observance of the above could
compromise the safety of the appliance. In order to guarantee the efficiency of the
appliance and its proper operation it is indispensible to keep to the manufacturer's
directions, by ensuring the periodical servicing of the appliance is carried out by pro-
fessionally qualified personnel.
• As soon as one decides not to use the appliance further, one should take care to ren-
der innocuous those parts liable to be potential sources of danger.
• The transformation from a gas (natural gas or liquid gas) to a gas of another group
must be made exclusively by qualified personnel.
• Before starting up the burner ask qualified personnel to check:
a) that the data on the information plate corresponds to that required by the gas, and
electrical supply networks;
b) that the calibration of the burner is compatible with the boiler output;
c) that the comburent air flow and the fumes evacuation take place properly in accor-
dance with the regulations in force.
d) that correct aeration and maintenance are possible.
• After each reopening of the gas cock wait a few minutes before restarting the bur-
ner.
• Before carrying out whatever intervention which foresees the dismantling of the bur-
ner or the opening of any of the accesses for inspection, disconnect the electrical cur-
rent and close off the gas cocks.
• Do not deposit containers of inflammable substances in the location where the burner
is situated.
• On noticing the smell of gas do not touch any electrical switch. Open all doors and
UK
windows. Shut off the gas cocks.
27