Dometic FJ1700 Instrucciones De Montaje página 15

FreshJet
➤ Connect the two cables of the remote light switch to the 2-pin plug (3).
➤ Insert the 2-pin plug (3) into socket on the circuit board.
12 Vg cable
You can connect the lighting to the battery. This enables you to switch on the lighting
even if the 230 Vw voltage supply is not connected.
To do this, proceed as follows:
➤ Connect the positive cable and the negative cable to the battery.
Connecting the circuit board
See fig. e
➤ Insert the 12-pin plug (1) in the socket (3) on the circuit board of the air outlet unit.
➤ Connect the 2-pin connector plug (2) to the wire from CI-Bus master panel
(optional).
8.6 Installing the air outlet unit Chillout ADB
See fig. f
➤ Attach the air outlet unit to the (1) fastening frame using the short fastening
screws.
See fig. g
➤ Install the air filter in the specified sequence.
See fig. h
➤ Fit the filter covers.
➤ Enter the new vehicle height and weight in the vehicle documents.
8.7 Installing the roof air conditioner with ADB
A
NOTICE! Damage hazard
Observe the structural strength of the roof of the vehicle. The roof of the
vehicle must be able to bear the weight of the roof air conditioner. The
roof must not be indented or deformed by the weight of the unit, even
over a longer period of time.
EN
Installation
15