Set Brightness Of Display; Using The Emergency Switch (Where Fitted) - Dometic CFX Serie Instrucciones De Uso

Operation
➤ Hold the "UP +" (fig. 3 7, page 4) button for at least five seconds.
✔ In both displays "rES" will blink several times before returning to the previous dis-
play.
✔ The WiFi settings have been reset to factory settings.
For additional information visit the Dometic website from which you downloaded
the app.
7.8

Set brightness of display

The display brightness can be dimmed for low ambient light conditions. To set the
dimming level of the display proceed as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 4, page 4) four times.
➤ Use the "UP +" (fig. 3 7, page 4) or "DOWN –" (fig. 3 6, page 4) buttons to
set the brightness of the display.
✔ Display will be as follows:
d0 (default), d1 (medium), d2 (dark)
✔ The display shows the set mode for some seconds. The display flashes several
times before it returns to the current brightness.
I
NOTE
• The factory setting of brightness of the display is d0 (default).
• If a fault occurs, the brightness automatically is d0 (default). After
troubleshooting the set brightness is reactivated.
7.9

Using the emergency switch (where fitted)

The emergency switch (fig. 5 1, page 4) is located below the control panel on all
models except CFX28 where it is located above the power inlet sockets. For normal
operation the switch is in the "NORMAL USE" position.
➤ If an electronic control failure occurs, slide the switch to "EMERGENCY
OVERRIDE" position
I
NOTE
If the switch is in the "EMERGENCY OVERRIDE" position, the cooler runs
with full cooling capacity and may freeze.
20
CFX28 – CFX65W
EN