Replacement Parts - Shark SV1106 N Guia Del Usuario

TROUBLESHOOTING GUIDE & REPLACEMENT PARTS
PROBLEM
Vacuum will not operate.
Charging indicator does not
illuminate.
Motorized brush will not work.
Vacuum will not pick up or suction
power is weak.
Dust escapes from vacuum.
Vacuum turns off on its own.
Run time has decreased over time.

REPLACEMENT PARTS

XA1106N
Charging Adapter
XBT1106N Battery pack
XF1100 Filters (2)
1066FT1106
Charging Stand
25 1-800-798-7398
SUGGESTED SOLUTION
1 The battery may be depleted. Charge the vacuum until half of the oval flashes,
indicating a full charge.
2 See "Restarting after a jam" on page 23.
1 Check to see if the charge adapter is plugged in properly to the outlet and to the
charging jack in back of the motorized floor nozzle.
2 Ensure there is no debris accumulated on the metal charge contacts on the back of
the motorized floor nozzle and on the charging adaptor.
3 E nsure that the electrical outlet is supplying power to the charger. Check the fuse/
breaker.
1 See "Cleaning the Motorized Floor Nozzle and Clearing Blockages" on page 21 and
"Restarting after a jam" on page 23.
2 Ensure that the motorized floor nozzle is properly attached.
1 Empty the dust cup container.
2 Remove the dust cup filter, check for blockages and remove. Clean or replace the
dust cup filter (See "Replacement Parts" below). Note: It is important to clean the
dust cup filter every month.
3 The battery may need to be charged, charge until half of the oval flashes, indicating
a full charge.
4 Ensure that the motorized floor nozzle is properly attached.
1 Empty the dust cup container.
2 Ensure that the filter is inserted completely into its holder below the dust cup.
3 Check for punctures in dust cup filter or cracks in the dust cup and replace.
1 Charge the unit until half of the oval flashes, indicating a full charge.
1 Perform the following steps:
a Charge the vacuum until fully charged (minimum of 4 hours).
b Run the vacuum until it turns itself off.
c Charge the vacuum until fully charged.
For any other servicing, call
Customer Support at 1-800-798-7398
or visit www.sharkclean.com