Safety Warnings - Astralpool LUMIPLUS PAR56 LAMP Manual De Instalación Y Mantenimiento

If you have a remote control, apart from the modulator operations, you can also switch colours of a sequence on and
off and select the switching off time.
Electrical connection diagram (see diagram page 26)
For correct installation, you will need the Modulator, the transformer and finally the LEDs lamp. As an option, this
system can be controlled by Remote Control.
The Modulator is connected to the 230 V~ac mains by means of two terminals indicated MAINS, and to the primary
input of the transformer (230 V~ac) by means of the terminals indicated TRF.
The Transformer must be dimensioned to supply the corresponding VA to each LED lamp which is connected (see table
on back page). For example, if we want to control 4, 64VA PAR56 V2 lamps we must connect them in parallel to a
minimum 300VA transformer.
Each modulator can support up to a maximum of 900VA.
Once the unit is connected, proceed as follows to start-up the projector for the first time:
Switch on the unit by activating the 230 V~ac at the input of the Modulator, which will automatically syntonize with the
transformer. The green LED of the Modulator will flash every 2 seconds and the lamp will remain off.
Types of lighting
The Remote Control – Modulator – Transformer – LED Projector unit enables you to create different lighting settings
inside the pool with two operation options:
Set colour: Selection of a set colour among twelve possibilities.
COLOUR Nº
1
2
3
4
5
6
Automatic sequence of colours: Selection of eight colour sequence programmes. Each programme is defined by the
lighting time of each colour and the transition time from one colour to another according to the following table:
SEQUENCE
1 Red Green
2 Cyan Magenta
3 Green Esmerald green
4 Red Orange
5 Red Pink
6 Red Orange
7 Pale violet Magenta
8 Red Green

7. SAFETY WARNINGS:

• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIM-
MING POOLS.
• This lamp is suitable for use in seawater unless projector specifications state otherwise.
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric com-
ponents which have been inserted or handled at locations other than its own premises.
• The PAR56 lamp of LEDs withstands to the treatments of swimming pool described next as long as the values of
concentration do not surpass the following values:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
COLOUR
Red
Green
Blue
Yellow
Cyan
Magenta
Blue
Yellow
Cyan Sky-blue
Green Orange
Blue Pink
Green Cyan
Cyan Yellow
Blue Yellow
TYPE OF TREATMENT
COLOUR Nº
ORDER OF COLOURS
Blue Pink
White Yellow Cyan
Cyan Magenta Pale violet Sky-blue
CONCENTRATION IN WATER
4
COLOUR
7 Pale violet
8 Sky-blue
9 Orange
10 Pink
11 Emerald green
12 White
Magenta
Orange Pink
2 mg/l
5 mg/l
-
Esmerald green White