Troubleshooting - Black and Decker Smartselect BDPH200 Manual De Instrucciones

This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other
rights which vary from state to state or province to province. Should you have any questions, contact the manager of
your nearest Black & Decker Service Center. This product is not intended for commercial use.
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For products sold in Latin America,
check country specific warranty information contained in the packaging, call the local company or see the website for
warranty information.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call
1-800-544-6986 for a free replacement.
Problem
• Material runs or drips.
• Too much over spray.
• Little or no material being released.
• Material being sprayed is splattering.
• Sprayer pulsates.
• Liquid comes out side of canister.
For assistance with your product, visit our website www.blackanddecker.com for the location of the
service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.

TROUBLESHOOTING

Possible Cause
• Spraying too much material.
• Spraying too slowly.
• Spraying too close.
• Viscosity too thin.
• Sprayer too far from surface.
• Too much material being sprayed.
• Check valve ball stuck.
• Spray nozzle/tip clogged.
• Pickup tube loose or clogged.
• Material adjustment knob setting too low.
• Air inlet blocked.
• Material too thick.
• Viscosity of material is too high.
• Air filter clogged.
• Material in canister almost empty.
• Lid not on square or tight enough.
• Paint on threads of canister and lid.
Imported by
See 'Tools-Elec-
– Yellow Pages –
12
Possible Solution
• Reduce air flow by turning
material adjustment knob.
• Increase speed of application.
• Increase distance from surface.
• Check dilution
recommendation.
• Reduce distance to surface.
• Reduce air flow by turning
material adjustment knob.
• Remove check valve. Depress
ball to loosen.
Add lubricant. See figure Q.
• Clean nozzles.
• Check tube.
• Increase setting.
• Clean or change air filter.
• Check viscosity
recommendation.
• Thin material per manufacturer
recommendation.
• Clean or change filter.
• Refill canister.
• Remove lid and reattach
squarely and evenly, then tighten
lid securely.
• Clean threads on top and sides
of canister and lid.
tric'
for Service &
Sales