Front Glass Installation - Dimplex BLF34 El Manual Del Propietario

Fireplace Installation
against the wall (Figure 9).
4. Use the supplied bubble level
to level the fireplace within the
framing, adjust as required.
5. Drive four supplied mounting
screws through the four mount-
ing holes located on the inside
surface of the fireplace chassis,
into wall studs (Figure 10).
6. Refer to Front Glass Installa-
tion section, page 15 for final
installation procedures.
Figure 11
Front glass
assembly
Hooks (4)
Mounts (4)

Front Glass Installation

1. Evenly distribute supplied
2. Carefully mount front glass
3. Use the supplied two Phillips
4. Ensure the fireplace's On/Off
Front tray
5. If unit is not hard-wired, plug
Figure 12
glass rock on the front tray of
the fireplace (Figure 11).
assembly so that the front
glass hooks hang on the front
glass mounts on the fireplace
(Figure 11).
sheet metal screws to fasten
the glass assembly tabs to the
fireplace (Figure 12).
Switch is switched to the Off
position (refer to operation
section).
fireplace into a 15 Amp, 120
Volt outlet (refer to NOTE 1).
Tab
15