Fireplace Installation; Mantel Installation - Dimplex DF3033ST El Manual Del Propietario

Fireplace Installation

WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: To reduce the risk
of fire, do not store or use gaso-
line or other flammable vapors or
liquids in the vicinity of the heater.
CAUTION:
circulation beneath the fire-
place insert is provided by two
(2) rubber feet.
Do not install the fireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION:
fireplace in a carpeted area, place
Clearance for air
If installing the
a one-piece, solid, flat surface
under the fireplace. Ensure that
both of the feet rest securely on
this surface.
!
NOTE: The dimensions of the
fireplace are 31 ½ in. (800
mm) wide x 22 ⅜ in. (568 mm)
high x 9 ⅛ in. (232 mm) deep.
The fireplace does not require
any additional venting.

Mantel Installation

Install the fireplace into the
mantel (refer to mantel assembly
instructions).
!
IMPORTANT: If not using a
Dimplex mantel, the fireplace
must be installed in an enclosure
with the following minimum inter-
nal/opening dimensions (Figure
1).
Figure 1
9 ½ in.
(241 mm)
22 ¾ in.
(578 mm)
31 ¾ in.
(807 mm)
7