Attention - Service Lines; Original Ancillaries / Accessories; Safety Advice Relating To Cordless Drill Drivers; Before First Use - Parkside X 14,4-LI Instrucciones De Utilización Y De Seguridad

Taladradora con batería de iones de litio
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General safety... / Safety advice relating to cordless drill drivers / Before first use

Attention - Service lines!

Q
WArnInG!
Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.
Original ancillaries /
Q
accessories
J
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and
accessories other than those recommended in
the operating instructions could lead to an
increased risk of personal injury for you.
Safety advice relating
to cordless drill drivers
J
Securely support the workpiece. A
workpiece held in a clamp or vice is kept more
securely in place than one held by your hand.
WArnInG!
POISOnOUS DUSTS!
J
Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area.
J
Wear safety glasses and a dust
mask!
J
Do not drill any material containing
asbestos. Asbestos is a known carcinogen.
J
Hold the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
J
If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
WArnInG!
The inserted tool may
strike concealed electricity cables,
30 GB/MT
E3335_Akkubohr-Schrauber_Content_X14.4V_LB5.indd 30
therefore when working you must
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.
J
Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.

Before first use

Q
removing / charging / inserting
Q
rechargeable battery pack
WArnInG!
Always disconnect the mains
adapter
from the mains supply before you
10
remove or insert the battery pack from/into the
charging station
.
12
note: The battery is supplied partially charged.
Charge the battery in the charging station for at
least three hours before first use. By doing this the
battery will operate at its highest capacity. You can
charge the Li-Ion battery at any time without risk of
shortening battery life. Interrupting the charging
process does not damage the battery.
1. To remove the battery pack
tery unlocking button
pack
forward off the device.
6
2. Push the battery pack
charging station
.
12
3. Insert the mains adapter
socket. The mains adapter LED
4. Connect the mains adapter
station
. The charging indicator LED
12
the charging station
12
5. The green charge indicator LED
the charging process is complete and the
battery pack
is ready for use.
6
6. To remove the battery pack
battery unlocking button
press the bat-
6
and pull the battery
7
from the front into the
6
into the mains
10
illuminates.
11
to the charging
10
on
13
illuminates red.
shows that
13
press the
6
and pull the
7
22.04.2008 16:23:11 Uhr

Publicidad

Tabla de contenido
loading

Tabla de contenido