Parts And Components - WAGNER RENUVO Manual De Usario

Note: The graphic below shows the Renuvo
components as they are out of the box. Some
parts will have to be assembled prior to use.
See "Assembly" instructions, below.
Pad connection
Pad assembly
quick-release tabs
Pad assembly
Brushes
Assembly
Note: Depending upon how your Renuvo was
packaged, some assembly may be required. These
steps will only have to be performed once.
1. Remove the piece of tape that is stretched across
the top of the lower container assembly (a).
Note: A rod is located inside the tube of the lower
container assembly (e). After removing the tape,
make sure this rod does not slide out. If it does,
make sure it gets replaced with the large flange (b)
side going in first.
2. While holding in the snap buttons (c) on the
upper handle (d), slide the upper handle into the
lower container assembly (e).
3. Slide the upper handle down into the lower
container assembly until the snap buttons "click"
into the holes on the lower handle.
Note: The holes on either side of the lower
container assembly are different sizes. Make sure
the snap buttons in the upper handle are lined
up with the correct holes in the lower container
assembly.
iMpORTaNT: Once the Renuvo is assembled,
DO NOT attempt to disassemble the handle.
attempts to disassemble could permanently
damage the unit.
English
2

Parts and Components

Lower container
assembly
Removable
container
Container
quick-release tabs
Upper
handle
d
c
a
e
© Wagner Spray Tech. - All Rights Reserved
d
e
c
b
e