Seca 685 Manual De Instrucciones Y Garantía página 30

17. Pass the connector cable for the dis-
play downward, from the top right
through the right rear side post (8).
Note: Do not remove the cable tie on
the connector cable. When laying the
connector cable, make sure it is not
pinched or twisted.
18. Place the covers (9) on the left and
right end of the transverse bar.
19. Initially fasten the covers on the two
outer holes using the B 3,5 x 9,5
pan-head tapping screws.
20. Place the support and display (10)
onto the upper transverse bar. Next,
fit the bolts on the inner holes of the
covers.
21. Connect the connector cable to the
electronics box (11).
22. Screw-tighten the folding seat (12)
from the rear onto the left side piece
using the M6 x 20 oval head screws
and plain washers.
23. Remove the cable ties from the legs
of the folding seat.
24. Place the appropriate covers on the
countersunk bolt heads.
30
9
10
9
8
11
12