Samsung WA50F9A6D Manual Del Usuario página 3

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
Error Code
NO
(Diagnostic Code
Error Image)
12
13
14
15
16
17
18
(Clutch Motor Error)
19
(clutch hall sensor
error)
F900A WASH_WA50F_ MANUAL_DC68-03132C_EN（需要翻译的文件）.indd 3
WARNING
Description
The hot/cold water hose connection
is not correct.
Suds is detected during the washing
session. ("SUd" or "Sd" is not an error.
When it finishes washing, End and
the "SUd" or "Sd" code will blink in
turn.)
Communication error between SUB
PBA and MAIN PBA
If the MEMS communication error or
MEMS trouble diagnosis error occur,
this message will be displayed.
A button except the Power button is
continually pressed.
The hot/cold water hose connection
is not correct.
This error occurs when the position
of the clutch is not detected.
- If the position detection signal is
not received 15 seconds after the
clutch motor starts, the spin drum is
shaken left and right and then the
motor is restarted.
If the motor position signal is not
received even after 3 reattempts, a
PE error occurs.
After the completion of the clutch
position detection, and the clutch
hall signal is invalid, the spin drum
is shaken left and right and then the
clutch hall signal is evaluated again.
This, if the clutch hall signal is still
invalid, the clutch position switching
status is checked and then the
operation is restarted.
(If the 15 reattempts fail, this error
occurs.)
3
Corrective Action
Please connect the hot/cold water
hose connection correctly.
Guide a user to reduce amount of
detergent usage.
Check Main PBA, SUB PBA & Wire-
harness. Replace PCB
1. Check the MEMS sensor and PBA.
2. Check the wire connector
terminals
Check whether either the Power
switch or a tact switch is continually
pressed
Please connect the hot/cold water
hose connection correctly.
1. Check the clutch motor.
2. Check the assembly status of the
clutch motor.
3. Check the wire connector
terminals.
1. Check the clutch hall sensor.
2. Check the wire connector
terminals.
3. Check the clutch switching status.
- Check the coupling assembly and
disassembly status.
2013-1-21 14:58:13