Workplace Assembly; Assembly Note; Check The Delivered Objects; Packaging - Hammerbacher XMST-Serie Manual De Instrucciones

5. Workplace assembly, page 116-118

5.1 Assembly note

Please ensure before each initial operation,
• that the disk was correctly assembled
• that the controls are connected to the motor via the cables
• that all the safety regulations are observed
• before initial operation it is necessary to carry out a
• you can find the directions in the assembly instructions
Assemble the frame using the included tools.

5.2 Check the delivered objects

• Open the box carefully
• Do not use long knives as they could damage the components.
• Check the contents are complete using the list on page 116 .
• Check the contents for visible transport damage, paying particular attention to the electric
cables. In the event of damaged or incorrect components please contact our customer
service.
• Do not try to assemble the frame if there is any damage or any incorrect components.

5.3 Packaging

Dispose of the packaging in domestic waste / cardboard.
Please observe the statutory waste disposal regulations.
Assembly instructions XDSM 12/16/19/20
48
XMST
Note:
The desk can be infinitely adjusted using the electric motor between
heights of 720 and 1190 mm.
reset process