Other Errors Or Faults - Hammerbacher XMST-Serie Manual De Instrucciones

8.2 Other errors or faults:

Fault
Desk is moving more
slowly than normal
Desk only drives down
slowly
Lift or lower process is
not reacting
Desk only drives
upwards or downwards
or
Desk moves in jolts
downwards
Instability of the desk
Desk only drives briefly
to one side and then
stops
Unusual noises
One-sided or uneven
lifting or lowering
process
54
XMST
Possible cause
Permitted total load of
approx. 70 kg exceeded.
New initialisation necessary
for the controls
Foreign bodies or dirt
blocking the area of the
telescopic pole
No or deficient power supply
Missing or loose connection
to the drives or side sections
Missing connection to the
control panel
Defective drive
Defective motor controls
Defective operating panel
Loss of information from the
control
Defective drive
Defective motor control
Tensions exist because of
incorrect assembly
Incorrectly inserted and fixed
plate traverse
Loose screws
Missing or loose connection
to the side sections / drives
Defective drive
Telescopic pole is blocked by
dirt or foreign bodies
Control error
One-sided heavy load
Measure
Reduce or remove load
Carry out RESET (see page
power down,
re-initialisation)
Remove foreign body / dirt
Check cable connections and power supply.
(Fuse on building side)
Check plug connections on the drives and the
motor cable on the controls and reinstate as
necessary.
Check plug connection on the controls and
reinstate as necessary
Contact the Service Hotline, repairs and
replacement parts.
Contact the Service-Hotline, repairs and
replacement parts.
Exchange the
operating panel
• Disconnect from mains
• Re-connect the same
Carry out RESET (see page 40,
power down, reinitialisation)
Contact the Service-Hotline, repairs and
replacement parts.
(Contact p. 40 )
• Release the screws
• Drive to the top position
• Drive downwards
• Tighten screws
Check the plug connections on the drives and
on the control – reinstate if necessary
Contact the Service-Hotline, repairs and
replacement part.
Stop the lifting or lowering process immediately
Remove the dirt of foreign bodies
Stop the lifting or lowering process immediately
Contact the customer service department
Remove or centre the load
Drive the desk upwards or downwards until it
stops automatically
40, as reset following
as reset following