Greentouch 1028FM-33-201 Manual De Instrucciones página 5

SAFETY INFORMATION
• To prevent a possible fire,
air intakes or exhaust in any manner. DO
NOT use on soft surfaces, like a bed, where
opening may become blocked.
• The heaters MUST NOT be located
immediately below a socket-outlet.
• ALWAYS plug heaters directly into a wall
outlet/receptacle. NEVER use with an
extension cord or re-loadable power tap (outlet
/ power strip).
• DO NOT slide insert on top of wood to avoid
scratching wood surface.
• DO NOT place any objects on top of insert
and top air intake vents as this will cause unit
to overheat and can cause a fi re.
• DO NOT insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the
heater.
A
Grounding Pin
(CONT'D)
DO NOT block
SAVE THESE INSTRUCTIONS
B
Metal
Screw
Cover of
Grounding
Box
Electrical Connection
• A 15-Amp, 120-volt, 60 Hz circuit with
a properly grounded outlet is required.
Preferably, the fireplace will be on a dedicated
circuit as other appliances on the same circuit
may cause the circuit breaker to trip or the
fuse to blow when the heater is in operation.
The unit comes standard with 6-ft. three-wire
cord, exiting from the rear of the fireplace.
DO NOT exceed the current rating of the
current tap. ALWAYS plug heaters directly
into a wall outlet/receptacle. NEVER use with
an extension cord or relocatable power tap
(outlet/power strip).
Grounding Instructions
• This heater is for use on 120 volts. The cord
has a plug as shown below. See illustration
for grounding instruction. An adapter as
shown at C is available for connecting
three-blade grounding type plugs to two-
slot receptacles. The green grounding
lug extending from the adapter must be
connected to a permanent ground such as
a properly grounded outlet box. The adapter
should not be used if a three-slot grounded
receptacle is available.
C
Grounding Means
Adapter
5
D
Grounding Pin