Operation; Gate Volume; Alarm Mode; Trigger Time - Marmitek DOORPHONE 170 Modo De Empleo

OPERATION

1. Switch on the handset with a long press (over 3 seconds) of the
Power ON/OFF button (15)
case you want to switch off the unit.
2. The power indicator (19) will light up blue. In case the Li battery has
run down, the power indicator will start flashing blue. At the same
time, the battery icon
and flashing. Place the unit into the charger stand to charge up the
battery. During charging, the segments inside the battery level icon P
will flash in turn irrespective if the unit is switched on or off. To
protect the battery, if the unit is not being re-charged when the icon O
shows up, it will be switched off automatically after 10 minutes.
3. During standby mode, short press of the Talk/answer button
(16) will initiate the backlight and activated the touch keys
Long touch the menu key
mode & LCD show following:

GATE VOLUME

This will set the speaker volume of the door unit. Use
the left/right key
levels with 1 being the lowest and 4 being the highest
volume. Short touch the menu key
your setting.

ALARM MODE

This will set the method of alert when a visitor calls,
either with a ding-dong sound or vibration or both. Use
the left/right key
(ding-dong sound and vibration) or
sound only) or
key (11) to confirm.
The corresponding icon will be shown on the top of the LCD (18).

TRIGGER TIME

This is the duration time for how long the door lock is being
triggered. Use the left/right key
between 2, 8, 15, or 30 seconds. Short touch the menu
key (11) to confirm.
16
shown on the LCD (17) will become empty
(11) for over 3 sec to enter programming
(9) (10) to select between the 4
(9) (10) to select between
(vibration only). Short touch the menu
(9) (10) to select
. Press the same button again in
(11) to confirm
(ding-dong
/
© MARMITEK