Atlantic Shanghai 2 Manual Del Usuario página 9

9) Using the on/off pass program system ref; 602019
When using programming mod (clock symbol) with the on/off passé program system (interface+ timer), the moon
symbol on the timer refers to the off mode (no heating).
Warning : the control unit will consider the off signal in any switch selection.
This device is not intended for use by persons (including children) with physical, sensory or mental
disability, or by persons lacking experience or knowledge, unless they have received from a person in
charge of their safety adequate supervision or preliminary instructions on how to use the device.
Care must be taken at all times to keep children from playing with the device.
Do not introduce objects or paper into the device.
Do not totally or partially block the grilles on the front or inside of the appliance, as this may cause overheating.
If the supply cord is damaged, it must be replaced by a service agent or similarly qualified person in order
to avoid a hazard (applies to units fitted with a supply cord and plug). Units fitted with a three core supply
cord (brown, blue & black), must be directly connected to fixed wiring by a licensed electrician. All work on
the interior of the appliance must be carried out by a licensed electrician.
To maintain performances of your unit, you should clean the upper and lower grilles of the unit about twice a year using
a vacuum cleaner or a brush.
Have a professional check the inside of the unit every five years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is due to the poor quality of
the ambient air. In this case, it is recommended to check that the room is well ventilated (ventilation, air inlet, etc.),
and that the air is clean. The unit will not be replaced under the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.
If the unit does not heat :
Check that the programmer is in COMFORT mode (electronical).
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you have one) has not
switched off the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders : (version with pilot wire)
Make sure that the programming unit is being correctly used (refer to its user's manual) or that the Chronocarte is
properly inserted in its housing and that it is operating normally (batteries ?).
The unit is permanently heating :
Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be distribued by some severe mains voltage
disturbances (outside EC standards defining the disturbance protection level). If there are any problems (thermostat
blocked, etc.) switch off the unit power supply (fuse, circuit breaker, etc.) for about 5 minutes to allow the unit to start again.
Have your energy distributor check your power supply if the phenomenon occurs frequently.
USING THE PANEL HEATER suite
WARNINGS
MAINTENANCE
TROUBLE-SHOOTING
8