Connecting The Torch And The Welding Device - Abicor Binzel ABIDRIVE V2 Instructivo De Servicio

TIG cold-wire feeder
7 Attach the full-floating axles (4) and close the pressure rocker (5).
8 Fold the pressure lever (1) back into the vertical position.
Use the pressure lever (1) to set the necessary contact pressure.
9 Close the cover.

6.11 Connecting the torch and the welding device

The wire feeder can be controlled using an appropriate standard torch.
Wire on Power on
T2 T4
T1
Up wire Down wire
Fig. 18 Standard torch activates the power source via pins 5+6
F5=A
F5=b
F5=C
Start wire feed
UP wire feed
DOWN wire retraction
Fig. 19
The welding power source can be optionally triggered by the start welding signal from the wire feeder. The signal occurs via
pins 1+2 (X2).
 6.4.4 4-cycle and interval with torch for controlling the power source via the feed on page EN-16
If welding is started via pins 1+2, the wire feed and welding process can both be started using rocker T2 on the welding
torch. This mode is recommended for automated welding as the wire feed and the welding process can be started via one
signal.
For manual welding, the welding process is started using the separate torch trigger.
 Fig. 18 Standard torch activates the power source via pins 5+6 on page EN-23
BAL.0415.0 • 2018-10-22
Control lead
(shielded)
T3
T1 = 1+3
T2 = 1+2
T3 = 1+4
Neutral
T4 = 5+6
X1
1
Start wire feed
2
T2
Wire feed
3
T1
4
Wire retraction
T3
X1
1
Start wire feed
2
T2
UP wire speed
3
T1
4
DOWN wire speed
T3
X1
1
2
T2
3
T1
4
T3
6 Putting into operation
Amphenol con
14-pin
2
BN
GN 6
5
WH
GY 3
4
PK
1
YE
n.c.
7
n.c.
8
n.c.
9
n.c.
10
n.c.
11
n.c.
12
n.c.
13
14
KDW S
KDW S
KDW S
EN - 23