Supplied Items; Technical Specifications; Safety And Instructions; Technical Safety - BORETTI Beermachine Manual De Instrucciones

CONTENTS
1. SUPPLIED ITEMS
2. TECHNICAL SPECIFICATIONS
3. SAFETY AND INSTRUCTIONS
4. DISPOSAL OF HOUSEHOLD APPLIANCES
5. INSTALLING THE APPLIANCE
6. CONNECTING AND REPLACING THE CO² CYLINDER
7. REGULATING CO², TEMPERATURE AND SERVING BEER
8. MAINTENANCE AND CLEANING
9. REPLACING THE KEG
1.

SUPPLIED ITEMS

• CLEANING TABS 1 PACK OF 10 TABS
• 4.5 x 35 SCREWS NR. 04
• 4.5 x 18 SCREWS NR. 02
• WASHERS NR. 04
• INSTRUCTIONS BOOKLET NR. 01
• SPATULA NR. 01
• WASHING ATTACHMENT FOR KORB (S-SYSTEM) NR. 01
• WASHING ATTACHMENT FOR FLACH (A-SYSTEM) NR. 01
• DISPENSE HEAD FOR KORB (S-SYSTEM) NR. 01
• DISPENSE HEAD FOR FLACH (A-SYSTEM) NR. 01
2.

TECHNICAL SPECIFICATIONS

Operating voltage : 230 V-AC 50 Hz
Absorbed power : 190 Watt
Draught capacity : +/- 40 l/H (depends on the set pressure)
Cooling capacity: 465W/ 400 kcal/h
Sizes:
External: W 595 x H 458 x D 19
Internal: W 560 x H 450 x D 400
3.

SAFETY AND INSTRUCTIONS

This dispenser conforms to current safety regulations. Improper use of the dispenser may cause damage to people and/or objects. Carefully read the instructions
for use before operating the dispenser.
The instructions include important information on safety, use and maintenance to protect you and the machine. The dispenser has been exclusively designed for
serving beer. Any other use is not permitted and may be hazardous.
Boretti BV shall not be held liable in any way for damage caused to people or objects as a result of improper and/or incorrect use of the dispenser.

TECHNICAL SAFETY

Before connecting the dispenser to the mains, make sure the voltage and frequency on the rating plate are compatible with the electrical system.
The safety of the dispenser is only guaranteed if it is connected to a standard earthing conductor.
Boretti BV shall not be held liable in any way for damage caused to people or objects as a result of faulty operation of the earthing conductor (for example
the risk of electric shock).
Do not use extension leads to connect the dispenser. Extension leads do not guarantee safety conditions required for the dispenser (for example the risk of
overheating).
If the mains lead connecting the dispenser is damaged, it must be replaced by qualifi ed personnel, to prevent any risks.
To prevent considerable harm to the user, installation, maintenance and repairs must be undertaken exclusively by qualifi ed personnel.
To disconnect the dispenser from the mains, remove the plug from the socket without pulling the lead.
Do not open the dispenser cover, under any circumstances. Do not touch live electrical parts or leads and do not change the electrical structure of the dispenser,
as this may result in electric shock.
The cylinder contains high pressure CO² gas, pressurised to approximately 230 bar. Handle the cylinder with the utmost care and always close tap "O" (fi g.
1) even when the cylinder is empty. This tap should be kept closed, even when the machine is not used.
Boretti BV shall not be held liable in any way for damage caused to people or objects as a result of failure to comply with the above.
IC41
- Page 13
- Page 13
- Page 13
- Page 14
- Page 14
- Page 14
- Page 14
- Page 14
- Page 19
EN
13