Initial Setting; Initial Setup - Magnavox 32MF338B Guia Del Usuario

I
NITIAL SETTING
These operations are accessible by remote control. Some may also be accessible by controls on the main TV.

Initial Setup

This section will guide you through the TV's initial setting which includes
selecting a language for your on-screen menu and autoprogram, which
automatically scans and memorizes viewable channels.
Before you begin:
Make sure if the TV is connected to antenna or cables.
1
After making all the necessary connections, press
[POWER y y ] to turn on the TV.
• This operation may take a few moments.
2
Use [Cursor K / L ] to select the on-screen language
from the choices on the right side of the TV screen.
(English / Español / Français)
• "Initial Setup" menu on step 3 will be displayed in the
selected language after you press [OK].
3
Use [Cursor K / L ] to select "Air" for TV channels or
"Cable" for CATV channels, then press [OK].
• Scanning and memorizing of channels start
automatically.
• When the scanning and memorizing of channels are
completed, the lowest memorized channel will be
displayed.
14
EN
Initial Setup
Initial Setup
English
Select the language for setup display.
Elija el idioma de ajuste. Español
Sélectionner langue écran config. Français
MENU
Select OK Exit
OK
Initial Setup Initial Setup
Make sure the antenna is connected to "ANT.IN" jack.
Air
Select your signal source.
Cable
Air
Cable Or
ANT.IN
BACK MENU
Select OK OK Back Exit
Initial Setup Initial Setup
Now the system is scanning for channels, please wait.
2%
Analog channels 0 ch
Digital channels 0 ch
MENU
Exit
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER y y ] or [MENU] during autoprogram,
this setting will be canceled.
• The initial autoprogram function can be executed for
either "Air" or "Cable" only once. When you change the
connection (Air/Cable), set autoprogram again. (Refer to
page 15.)
• You can cancel or exit the initial autoprogram menu by
pressing [MENU].
• If there is no signal input from the antenna terminal and
no operation for several seconds after you turn on the TV,
"Helpful Hints" appears. Follow the instructions listed on
the TV screen.
No channel is registered.
Press and hold "OK" key on the remote control for 3 seconds.
Contact support hotline provided on manual or back of unit.
Sin canal registrado.
Pulse durante 3 segundos la tecla "OK" en el control remoto.
Llame teléfono de apoyo en manual o atrás de TV.
Pas de chaîne consign.
Enfoncez "OK" 3 secondes sur la télécommande.
Contacter numero d'urgence dans manuel ou arrière appareil.