Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A2 00
Auto-closing after pause time
00
OFF (auto-closing disabled)
01
15
NUMBER of closing attempts (stopped by photocell) before gate is left open permanently
-
99
tries to close with no limit on number of attempts
1-
NOTE: parameter
To enable auto-closing, you will need to set this parameter to a number other than
99
the value
will the gate always auto-close after the pause time, whatever the case. If, instead, you set a
number in the range
instance, if you set the value
gate is closing, the leaves would reopen but would not try to close again (they make just one attempt to
close).
The gate auto-closes only if the leaf reaches the fully open position.
NOTE: the value of parameter
have a value equal to but no greater than the value of parameter
A3 00
Closing after power cut
00
OFF (does not close when power is resumed)
01
ON (closes when power is resumed)
3-
NOTE: parameter
If this parameter is set to
flashing time (even if this has not been enabled via parameter
power cut while the gate is closing as it ensures the gate will close when power is resumed.
Following a power cut, the position of the leaves will not be known, so the gate is closed one leaf at a time
in "position recovery" mode.
A4 00
STEP-BY-STEP mode (PP)
00
OPENS - STOPS - CLOSES - STOPS - OPENS
STEP-BY-STEP APARTMENT BUILDING, from the fully open position, the PP command restarts
01
the pause timer
02
STEP-BY-STEP APARTMENT BUILDING, from the fully open position, the PP command closes the gate
03
OPENS - CLOSES - OPENS - CLOSES
04
OPENS - CLOSES - STOPS - OPENS
6-
NOTE: parameter
Apartment building means that the PP command is ignored while the gate is opening.
In installations where there is a chance that more than one user might arrive at the same time, and hence
use the remote control while the gate is operating, this option is useful for ensuring the gate completes its
opening cycle: it stops two commands given by different users from reversing movement and hence closing
the gate.
WARNING: setting apartment building mode (value
A2
(parameter
).
If the parameter is set to
gate, instead it restarts the pause timer.
34
in easy setup mode
01
15
to
, this is the maximum number of attempts the gate will make to close. For
01
and someone passes through the reversing photocells' beam while the
49
is dependent on the setting chosen for parameter
in easy setup mode
01
, the control unit, when it switches on, will close the gate after a 5-sec. pre-
in easy setup mode
01
and the gate is open, sending the step-by-step (PP) command will not close the
a2
.
A5
). This function is useful when there is a
01
02
and
) automatically enables auto-closing
00
; only by setting
a2
49
; parameter
can
Publicidad
Capítulos
Tabla de contenido
