RISCO Group WatchOUT PIR Instrucciones De Instalación página 10

7. Insert tamper wires and external cable wiring from Standard Swivel through knockout W1 on
the external base (Figure 6, Detail B).
8. Connect the external base to the swivel using the dedicated snaps (Figure 7).
Internal Base
PCB
NOTE:
Do not open or close the Swivel Assy Screw since it is used for connecting the swivel parts only.
9. Secure external base to swivel with two screws fastened to knockouts S1 and S2 (Figure 7).
10. Insert the supplied angle locking screw from the external base through the angle locking screw
knockout S3 on the external base to the standard swivel (Figure 7).
11. Tilt and Rotate the Standard Swivel to the desired position.
Once the Standard Swivel is in the desired position, secure
the angle locking screw.
12. Line up the internal base onto the external base. Insert all
wiring cables through the internal base.
13. Secure internal base to external base (Lock I1, Figure 2).
14. To readjust the Standard Swivel when the PCB is installed
(Figure 8):
a. Bend down the black foam located below the RED LED
on the PCB (enough to reach the Swivel locking screw).
b. Use a Philips screwdriver to release the locking screw
(see Figure 8).
c. Tilt and/or Rotate the Standard Swivel to the desired
position.
d. Secure the angle locking screw.
NOTE:
When marks on the two movable parts are aligned (Figure 7), the Standard Swivel is in 0
position. Each click from this position represents shifting of 5
15. Close the front cover (Lock C1, Figure 1) and walk test the detector.
NOTE:
The screw has to pass through External Base and locked to the swivel.
10
External Base
Swivel to External Base
Connecting Screws
S1
Angle Locking
Screw
(See Note 2)
Figure 7
WatchOUT PIR Installation Manual
See Detail A
Snaps
W1
S2
S3
Detail A
Swivel Assy
Connecting Screw
(See Note)
°
in vertical / horizontal position.
Figure 8
°
vertical /horizontal