Aiwa NSX-A888 Manual De Instrucciones página 22

MULTI
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Al: Artificial Intelligence)
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either
side,
1
2
3
4
5
Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press CD EDIT/CHECK ~.
When using the remote control, press
CD EDIT/CHECK
once
while pressing
SHIFT.
"EDIT" is displayed.
When "PRGM" is displayed, press
CD EDIT/CHECK.
Press DISC DIRECT PLAY 1-3 to select a disc.
Press numbered buttons O-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and O.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
++, - or
MULTI JOG
are also available to desi~nate
the tape length.
Remaining time Programmed
of recording tracks for side A
6 Press REC/REC MUTE to start recording on
the first side.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press W. Recording and CD play stop simultaneously.
To
clear the edit program
Press
CLEAR
twice so that "EDIT" disappears on the display.
To check the order of the programmed track numbers
Before recording, press
CD EDIT/CHECK
to select side A or B,
and press ++ or - repeatedly.
Programmed
Track number
track numbers
Tape side
Program number
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment
1
Press
CD EDIT/CHECK
to select side A or B.
2 Press
DISC DIRECT PLAY 1-3
to select a disc.
3 Press numbered buttons on the remote control to select tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
The Al edit recording function cannot be used with discs
containing 31 tracks or more. "TR OVER" is displayed if this is
attempted.
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
Tape side
A: First recording side
B: Second recording side
22
ENGLISH