Names And Functions Of Parts; Front Panel - Tascam BD-MP4K Manual Del Usuario

Names and functions of parts

Front panel

1
q
button and indicator
1
Use to turn the unit on and off (put it into standby).
The indicator lights red when the power is off (in standby)
and green when on.
V CAUTION
Before turning the unit on, lower the volumes of connected
equipment to their minimum levels.
Failure to do so could result in a sudden loud noise that could
harm hearing, for example.
ATTENTION
Do not turn the power on/off or disconnect the power cable
when the unit is playing any media or reading data from an
SD card or USB flash drive. Doing so could make the unit stop
operating properly and cause data on the SD card or USB
flash drive to be damaged.
2 Disc tray
Press the OPEN/CLOSE [LOCK] button to open the disc
tray and load/remove a disc. To close the disc tray, press the
OPEN/CLOSE [LOCK] button.
3 OPEN/CLOSE [LOCK]( - ) button
Use to open and close the disc tray usually.
Press while pressing the HIDE MENU [SHIFT] button to
enable the front panel lock function.
Repeating this operation changes the on/off status of this
lock function. (see "Panel lock functions" on page 31)
4 Remote control signal receiver
Signals from remote controls are received here. When
operating the remote control, point it toward this receiver.
5 Display
This shows various types of information.
6 HIDE MENU [SHIFT] button and indicator
Use this to enable the HIDE MENU function, which hides
the display of Home Screen icons as well as the play, pause
and other function icons. When the HIDE MENU function is
enabled, the indicator above the button will light orange.
In addition, while pressing this button, press the 3 or 7–0
buttons to use their shift functions, which are shown as light
characters on a dark background (Shift Mode). (see "Button
combination operations in Shift Mode" on page 12)
7 STOP [ENTER] (HOME) ( 8 ) button
When a video file is being played, paused or searched, press
this to stop that operation and return to the Home Screen.
When an audio file is being played, paused or searched, press
this to stop playback or searching.
When the Home Screen or Default Settings Screen is open,
press at the same time as the HIDE MENU [SHIFT] button to
enable Shift Mode, and use this as the ENTER button.
Press this button while pressing and holding the PLAY [ j ]
button to use it as the HOME button.
2 3 4 5 6 7 8 9 0
8 PLAY [ j ] ( y ) button and indicator
Press when stopped or in playback standby to start playback.
The indicator lights green during playback and is unlit at all
other times.
When the Home Screen or Default Settings Screen is open,
press at the same time as the HIDE MENU [SHIFT] button to
enable Shift Mode and use this as the move cursor down ( j )
button.
While pressing this button, press a button shown connected
to it (7, 9 or 0) to use its special function.
9 PAUSE [ k ] ( 9 ) (TOP MENU) button
Press when playing to pause playback.
When the Home Screen or Default Settings Screen is open,
press at the same time as the HIDE MENU [SHIFT] button to
enable Shift Mode and use this as the move cursor up ( k )
button.
Press this button while pressing and holding the PLAY [ j ]
button to use it as the TOP MENU button.
0 SKIP . / / [ l ]/[ ; ] ( m / , ) (REPEAT/A-B)
buttons
Press when playing or paused to skip to the previous or next
chapter or file.
(Playback will start after skipping.)
Press and hold when playing or paused to search backward/
forward. The search speed changes (among 5 speeds) each
time the button is pressed and held.
(To resume playback or to pause when searching backward/
forward, press the PLAY [ j ] ( y ) or PAUSE [ k ] ( 9 ) button.)
When the Home Screen or Default Settings Screen is open,
press at the same time as the HIDE MENU [SHIFT] button
to enable Shift Mode and use these as the left/right move
cursor ( l / ; ) buttons.
While pressing the PLAY [ j ] button, press the , button
to use it as the REPEAT button. While pressing the PLAY [ j ]
button, press the m button to use it as the A-B button.
q SD card slot
Insert an SD card in this slot.
Files, including video and music files, on the inserted SD card
can be played back. This can also be used to load update files
for firmware updates.
ATTENTION
Do not connect anything to the USB port when using an SD
card to conduct a firmware update. Do not insert an SD card
in the SD card slot when using a USB flash drive to conduct a
firmware update.
11
TASCAM BD-MP4K