Network Connection Overview - Tascam BD-MP4K Manual Del Usuario

Network connection overview

From the Home Screen, use Settings > General Settings >
Network to set the network connection.
1. In the submenu, set "Internet Connection" to "Enable".
Use the ; cursor or ENTER button to move to the function
setting. Use the j and k cursor buttons to select "Enable"
or "Disable" and press the ENTER button to confirm.
To exit a submenu, press the l cursor button repeatedly to
return to the first screen.
2. Set the method of Internet access for the unit to "Ethernet"
or "Wireless"* in the "Interface" submenu.
* "Wireless" connection can only be used if a USB-wireless LAN
adapter has been connected to the unit.
( A USB-wireless LAN adapter is not included with this unit.
Prepare one for use as necessary. For recommended wireless
LAN adapters, see the TASCAM website (https://tascam.
com/us/).)
Use the ; cursor or ENTER button to move to the function
setting. Use the j and k cursor buttons to select
"Ethernet" or "Wireless" and press the ENTER button to
confirm.
The following message will appear when the current setting
is changed.
To continue , select "Yes" and press the ENTER button.
o Using a wireless connection
The following connection methods can be selected.
i Scan
The unit will search for access points, allowing selection
of a network.
i Manual
An SSID can be set manually to connect.
i Auto
Connection is possible using Wi-Fi Protected Setup
(WPS) standards.
3. To use IPv6, set "IPv6 On" in the submenu to "Enable".
When enabled, "IP Protocol Priority" sets whether to
prioritize IPv4 or IPv6.
4. From the "IPv4 Information" submenu, network
information can be checked on the following screen.
Press the RETURN button to return to the previous screen.
o Information shown
Interface, address type, IP address, subnet mask, default
gateway, DNS1 and DNS 2.
5. When "IPv6 On" is set to "Enable", "IPv6 Information" can
be checked on the following screen.
Press the RETURN button to return to the previous screen.
o Information shown
Interface, Link-Local Address, IP address, Prefix, gateway,
DNS1 and DNS 2
6. The network can be tested with "Connection Test" in the
submenu.
The following messages appear if there is a problem with
the network connection.
i "Network FAILED"
i "Proxy FAILED"
7.
Select how the unit's IPv4 address is set in the "IPv4
Setting" submenu.
Problem with network
Problem with proxy
43
TASCAM BD-MP4K