Electrical Connections - Bossini Aquavolo Cromotherapy I02555 Instrucciones De Montaje

ELECTRICAL CONNECTIONS

- Connect the keyboard electrical cable A (13) to the control unit input of the electronic components group
(11), see (Fig. G and H).
- Connect the cable C from the transformer (14) to the cable gland (Fig. H).
NB: the electrician must use a bipolar electrical supply cable of 1mm² cross section, minimum outer diameter
GB
ø 5 mm – max outer diameter ø 13 mm.
-Fit the group (11) onto the wall support plate (1) (Fig. I).
-Apply the support cover (7) carefully, to avoid damage to the WideRain spray nozzles, until full adherence to
the wall (Fig. L) .
- Tightly fix the cover (7) onto the wall support with the special screws (8) (Fig. M).
- Remove the protection film (10) from the showerhead upper and lower surfaces (4) (Fig. M).
ELECTRICAL SYSTEM : TECHNICAL SPECIFICATIONS
1. Electrical supply ..............................................
Electricity consumption 0,1°
2. Supply cable.............................................
3. Box with transformer and filter ............................ (IP56) 7V ~/ 230V~ – 50/60 Hz for installation outside
4. Protection grade ....................................................
5. Electronic board....................................................... IP66/IP67
6. Control keyboard....................................................
7. Safety mark......................................................
8. Aquavolo .................................................................. 4led RGB max 3 watt
EC
Electrical systems in compliance with national and international regulations applied, must be made by
qualified technicians. A bipolar switch on the electrical supply (230V) must always be provided and it must be
accessible in order to enable the showerhead switching off in case of malfunction.
RECOMMENDATIONS FOR PROPER USE
Proper use of this product will allow you to avoid damages to the bathroom environment.
* To prevent impurities or debris from getting inside the product and causing functional problems,
always flush out the system before connecting it to the supply pipes. It is recommended to install
the filter at the system's water intake.
* To keep the diffuser clean and prevent lime scales from clogging the diffuser, we advise that you
periodically rub the silicone nozzles to free them of the lime deposits.
23
AQUAVOLO RGB
(Cod. I02555)
220/230V ~ – 50/60 Hz – 20va max
protection class II
bipolar 1mm² cross section It must have minimum outer
diameter ø 5 mm and a max outer diameter ø 13 mm.
(not included in the package)
the safety area (in compliance with
DIN VDE 0100 standard, part 10 –
according to CEI 64/8 Italian regulation)
IP x 5
IP65
EC