Cleaning The Interior; Main Components - Virtus 70/80 BRE Serie Instalación, Uso, Mantenimiento

Remove the bottom front panel.
Lower the well completely.
Disconnect the device's electrical connections.
Detach the connection with the pan lifting "bolt".
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
SCREW NUTS AND MANUAL PAN MOVEMENT
SYSTEM (BOLT)
Remove the bottom front panel.
Lift the pan completely, locking it fi rmly in that
position (e.g.with a bar).
Important: measure how far tightened the "bolt" is
with regard to the screw nut before removing the
components.
Disconnect the "bolt" from the handwheel shaft.
Undo the screw nut fi xings.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
MULTI-PURPOSE APPLIANCE
REPLACING THE HEATING AND LIGHT GLOWS.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the bottom of the
hotplate.
- Remove and replace the component.
- Insert the bulb properly in its seat on the bottom of
the hotplate.
- Reassemble all parts. For assembly, proceed in
reverse order.
21.

CLEANING THE INTERIOR

Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.
22.

MAIN COMPONENTS

GAS BRATT PAN
- Gas valve
- MAIN BURNER
- Pilot burner
- Thermocouple
- Igniter
- Solenoid fill valve
- Indicator light
- Working thermostat
- Safety thermostat
- Pan movement motor
- Pan movement microswitch
- Pan movement screw nut
ELECTRIC BRATT PAN
- Heating element
- Solenoid fill valve
- Indicator light
- Working thermostat
- Safety thermostat
- Pan movement motor
- Pan movement microswitch
- Pan movement screw nut
MULTI-PURPOSE APPLIANCE
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
31