Operation
keep pressed
26
STOP function
The cooking process can be briefly interrupted with the STOP function, e.g. if
the doorbell rings. The STOP function must be released in order to continue
cooking at the same power level. If a timer has been set it will pause and will
then continue.
This function is only available for 10 minutes for reasons of safety. The hob
will then be switched off.
1. Pots and pans are on the cooking zones and the required power levels
have been set.
2. Press the STOP key
another instead of the cooking levels previously selected.
3. The interruption is ended by firstly pressing the STOP key
pressing any other key (except the ON/OFF key).
The second key must be pressed within 10 seconds, otherwise the hob
will switch off.
Keeping warm function
With the function for keeping food warm
zones to keep food warm. The respective cooking zone is operated at a low
power level.
1. Cookware is placed on a cooking zone and a power level (e.g. 3) is
selected.
The stand-by dot of the cooking zone selected must light up. It may be
necessary to press a cooking zone selection key (e.g.
2. Keep the Minus key
(... 3, 2, 1,
). The setting will stop at
have been activated.
3. Press the Minus key
The function for keeping food warm is available for 120 minutes, after which
the hob will be switched off.
Locking
(if available)
(only for models with a lock button
The lock can be used to lock key operation and cooking level settings. Only
the Off key can be used to switch the hob off.
Activating the lock (while cooking):
1. Press the Lock key
the Lock key will light up. The controls are locked.
Switching off the lock
2. Press the Lock key
above the Lock key will go off.
Notes
• An activated lock will remain activated even if the hob is switched off. It
must therefore be de-activated when cooking is re-commenced.
• In the event of a power cut the lock will be cancelled, i.e. deactivated.
(if available)
. The letters S-T-O-P will be shown one after
(if available)
you can use one of the cooking
pressed to switch the power settings down
and the warming function will
once to de-activate the function (0).
)
to activate the function. The control lamp above
to deactivate the function. The control lamp
GB
and then
for front left).