Connecting An N1100-On Series Switch To A Power Source; Ac And Dc Power Connection - Dell N1108T-ON Guía De Introducción

NOTE:
port via the local CLI. Only one USB console session at a time is supported.
Connecting an N1100-ON Series Switch to a
Power Source
CAUTION:
Read the safety information in the
manual as well as the safety information for other switches that connect to or
support the switch.
The N1108T-ON and N1108P-ON models have one internal power supply.
The power receptacle is on the rear panel. N1108EP-ON uses an external DC
power adaptor. The external DC power adaptor

AC and DC Power Connection

1 Make sure that the switch console port is connected to a PC running a
VT100 terminal emulator via the USB to USB Type B cable.
2 Using a 5-foot (1.5 m) standard power cable with safety ground connected,
connect the power cable to the AC main receptacle located on the rear
panel.
The PoE model switches have a heavy-duty power cable with a notched
connector for the switch power receptacle. Use of this type of cable is
mandatory for PoE-capable switches.
3 Connect the power cable to a grounded AC outlet.
Console access to the stack manager is available from any console
Safety and Regulatory Information
Getting Started Guide
17