Publicidad
Idiomas disponibles
Idiomas disponibles
2.8.3. Cleaning the inside of the chimney and flue
smoke chamber and the exhaust gas fireplace. They are dirtier or less depending on the fuel
used, more or less slow progress of combustion, etc.. It is necessary to clean the chimney at
least once per season. To access the flue from the inside, it is necessary to remove the
deflector. A specialist is required to periodically review these elements.
2.8.4. Painting. The paint that covers the interior and exterior of the appliance, is designed to
withstand temperatures of to 600 ºC. The appliance finish will cure when first used. It may give
off unpleasant odours during the first few times of use. After few uses this smell will disappear
leaving only the pleasant smell of burning wood. It is possible that in some parts of the interior
of the chimney, after a period of use, may loosen the painted finish, due to corrosive liquids,
poor fuel quality or the use of unauthorised fuel type, etc. In this case it will be necessary to
repaint all the damages areas.
2.9.
In case of fire. No combustible material must be placed within 1000 mm of the
appliance. Take care when children or elderly people are around. In case of a chimney fire:
Evacuate the building, close all the air controls to shut down the appliance, call the fire brigade.
2.10. Operating in adverse weather. In certain weather conditions the appliance may not
operate correctly. In these circumstances close the appliance down.
2.11. Modification of the appliance. Modifications must be approved in writing by Rocal SA. It
is also compulsory to use parts recommended by Rocal SA.
3. TROUBLESHOOTING
This is a table with potential problems, the reason for them and solutions:
FAILURE
1.
Smoking
into
room / Insufficient flue
draught
2. Glass blackening
3.
Appliance
produces
little heat
3.
Smoke leaking
Through
doors
/
odour
The inspection of the chimney and the installation of the appliance must be carried out by a
competent person.
REASON
the
Incorrect flue draught
Insufficient air for combustion
Incorrect flue draught
Wrong type of fuel
Air slider position not set correctly
Wrong type of fuel
Insufficient fuel
Air slider malfunction
Burning the appliance for the first
bad
time
Combustible material too close to
the appliance
A crack in the appliance casting
It is important to keep waste clean the
(23).
SOLUTION
Ckeck the flue draught:
- Size
- Connection
- Are there any leaks
- Insufficient lenght
- Fire gone out
- Flue exit blocked
Check the flue draught entry
Other
ventilation
or
simultaneously
Check the flue draught.
Use the correct fuel
Adjust the air slider until glass clear
Use the correct fuel
Add fuel
Check the correct air slider is fitted and adjust
Wait for the paint and fixings to cure. This could
take several uses.
Check and insulate combustible materials
To Check for cracks. If the appliance is damaged:
contact the dealer/instalelr
heating
device
work
Página 15 de 23
Publicidad
