Tru-Test XRP EID READER Manual Del Usuario página 7

Mounting the XRP Reader
The XRP Reader can be mounted to a wall or other suitable surface, or on pipe-work, using the mounting bracket provided.
To install the mounting bracket:
1 Position the securing wire (a) as shown, with the two ends at the top.
2 Press the two ends of the securing wire into the top holes (b).
The lower horizontal section of the securing wire clicks into a groove in the rear of the bracket (c).
3 Fasten the mounting bracket to a steel or wood surface using the supplied screws, or to pipe-work using the supplied u-bolts. See (d) for
location of mounting holes.
7