List Of Symbols - DeWalt TSTAK DWST17510 Manual De Instrucciones

EN EN
LIST OF STANDARDS
The DEWALT ® TSTAK
• ANSI/UL60065:2015 Ed.8
• CAN/CSA-C22.2 No. 60065:2016 Ed.2
• ANSI/UL1310 (6th Edition rev. December
12, 2014)
CSA C22.2 No.223-M91 (Rev. September 2013)
•
IC RSS210: Issue 9: 2016
•
FCC
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1). This device may not cause harmful interference, and
(2). This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
3. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: To reduce the risk of fire or electric shock, DO NOT expose this appliance to
direct rain or moisture. Use only in dry locations.
WARNING: To prevent electric shock, match the wide blade of the adaptor plug to the wide
slot of the outlet and fully insert.

LIST OF SYMBOLS

The labels on this appliance may include the following symbols:
V Volts
A Amperes
W Watts
h hours
Direct current
Class II Construction
(double insulated)
8
® CONNECT RADIO + CHARGER complies with the following standards:
• ICES-003, Issue 6: 2016
• UL 2595:2015 Ed.2
• FCC part 15 Certification: 2016 (ANSI
C63.10 :2013)
FCC ID: YJ7DWST17510
•
IC: 9082A-DWST17510
•
Hz hertz
min minutes
Class II Construction (double insulated)
ETL Testing Laboratories symbol
Safety alert symbol
Read all documentation