Tractel mobifor Manual De Instalación, De Utilización Y De Mantenimiento página 7

"Full body harness": Body harness designed to arrest
falls. It consists of straps and buckles. It features fall-
arrest attachment points marked with an A if they can
be used alone, or marked with A/2 if they are to be used
in combination with another A/2 point. This is EN 361
compliant.
"Maximum operating load": Maximum weight of the
operator, equipped with the correct PPE, workwear,
tools and the parts they need to perform the task at
hand.
"Fall-arrest system": Equipment made up of the
following elements:
– Fall-arrest harness.
– Self-retracting fall-arrester, or energy shockabsorber,
or mobile fall prevention device with rigid
belaying supports, or mobile fall prevention device
with flexible belaying supports.
– Anchoring.
– Linking element.
"Fall-arrest system component": Generic term which
defines one of the following elements:
– Fall-arrest harness.
– Self-retracting fall-arrester, or energy shockabsorber,
or mobile fall prevention device with rigid
belaying supports, or mobile fall prevention device
with flexible belaying supports.
– Anchoring.
– Linking element.
"Dead weight anchor": anchor point for a fall arrest
system. It complies with standard EN 795:2012 type E.
"Anchor point": Location where the anchor point
should be connected to the operator.
"Belay lanyard": Connecting element between an
anchor point and a system to be secured.
"Shock absorber": Device for absorbing energy and
limiting the person's fall load.
"Sealing layer": Coating of a roof terrace to guarantee
sealing.
2.2. Pictograms
"DANGER": Placed at the beginning of the line,
refers to instructions to avoid injury to persons, including
death, serious or minor injuries, and damage to the
environment.
"IMPORTANT": Placed at the beginning of the line,
refers to instructions for avoiding a failure or damage to
equipment, but do not directly endangering the life or
health of the operator or that of others, and/or not likely
to cause environmental damage.
"NOTE": Placed at the beginning of the line,
refers to instructions to ensure the effectiveness and
convenience of installation, use or maintenance
operations.
Read the instruction manual.
Enter on the inspection sheet. Enter information
on the detachable inspection sheet located in the
central page of this manual.
Correct usage: correct use of the equipment.
OK
3. Function and description
The mobifor™ fall arrest system is a removable fall
arrest anchor point. It is fast and easy to install. One
of the main advantages of this equipment is that it can
be carried by hand in separate parts, and the entire
anchor point has a total weight of less than 25 kg. It
can be set up on roof or terrace without drilling the roof
cover, which reduces the risk of leaks and the need for
additional maintenance.
The mobifor™ fall arrest anchor point can be used on
PVC or bonded bitumen sealing coats in compliance
with directive 1907/2006/CE and standard ISO11014-1
and also EPDM type membrane (Two-leaf standard mix
synthetic vulcanised rubber 100% Ethylene-Propylene-
Diene Terpolymer) where the slope must be less than
5°.
The mobifor™ fall arrest anchor point is EN 795:2012
type E certified as a dead weight anchor point for 1
person.
GB
7